Operation
8
Raising machine from working to transport position
8.4
Vendro 680
Original operating instructions 150001223_01_en
59
2
1
KWG000-023
Open the stop cocks on the hydraulic hoses.
Set all hydraulic control units to the neutral position.
Switch on the tractor.
To release the locks (2), actuate the single-acting control unit on the tractor and apply
pressure to the hydraulic cylinders.
To loosen the locks (2), pull the operating cable (1) and keep it tensioned.
Use the single-acting control unit to slowly lower the outrigger arms until the wheels are on
the ground.
Release the operating cable (1).
Switch the control unit for field work to the float position.
8.4
Raising machine from working to transport position
WARNING
Risk of accidents due to raising the outrigger arms into transport position
While the outrigger arms are being raised into transport position, people may be caught and
be seriously injured.
Before raising the outrigger arms into transport position, switch off the PTO shaft and wait
until the rotors have come to a stop.
Do not raise the outrigger arms until you are absolutely sure that neither persons, animals
nor objects are in the swivel range.
NOTICE
Transport interlock must not be under load
The transport interlock of the outrigger arms must not be under load during transport.
Before transport, charge the hydraulic cylinders with pressure and then move the
hydraulic control unit into neutral position.