19
Type
PTO speed
Nm
TITAN 4/25 L
540
1350
TITAN 4/32 L
540
1490
Maximum connection angles
1. Connection (standard version)
Continuous
operation
25° >
Ensure equal joint
Brief operation 45° >
angles! Switch off if large
Standstill
90° >
and unequal joint angles
occur!
2. Wide-angle synchronised connection
Continuous
operation
25°
Brief operation 70/80°
(Depending on version)
Standstill
70/80°
(Depending on version)
Check slewing range and clearance for universal drive
shaft! Contact between universal drive shaft and tractor
or implement will cause damage (e.g. trailer equipment,
drawbar).
Overload couplings
Overload couplings protect tractor and implement from
damage. Therefore the guarantee is invalidated if the
set torque is altered by manipulation of the overload
safety device.
Attention! Compare the punched torque value (RM)
with the one in the table. If the values differ, please
contact your KRONE dealer.
The TITAN is equipped with a cam-type cut-out clutch
with a fixed torque value. If overloading occurs the
torque is interrupted. Full torque is then not available
until the PTO shaft has been switched off.
Always switch off the PTO shaft and the engine and remove the ignition key before cleaning,
lubricating or adjusting the PTO-driven implement or the universal drive shaft!
Ensure that no-one is in the danger area of the implement before switching the PTO shaft on.
Ensure that the PTO shaft speed selected at the tractor matches the permissible speed of the
implement before switching the PTO shaft on!
