Portable spectrum analyzer Arinst SSA-TG R2 6 April 2019
www.arinst.net | www.arinst.ru | www.kroks.ru
12
igure 11 Entering numerical values of marker frequencies
7.5.4. Moving the included markers on the screen in real time, make in accordance with paragraph
7.1.5. of this «Manual».
7.5.5. If it is necessary to search and track the maximum (peak) amplitude values over the entire range
of the signal under analyze, one or several
Marker
indicators must be switched to the
Peak
value as
shown in figure 12.
igure 12 The menu of markers and peak values of the signal
Peak
– visual indicator of the maximum value of the signal amplitude over the entire frequency range.
The design of the device allows the use of up to four multi-colored peak indicators to monitor changes in
the amplitudes of the analyzed signal over the entire range of the specified frequency range.
Switching on / off the
Marker
and
Peak
modes is made by moving the “slider” to the right / left oppo-
site the corresponding mode.
7.5.6. To exit the setup menu of markers and peak values of the signal, press the button (14)
«MENU»
.
7.6. Signal generator frequency and power setting menu
7.6.1. To set the values of the frequency and output power of the built-in generator, go to the main
menu of the device (Figure 6) by pressing the button (14)
«MENU»
. Select subsection
Generator
, menu
will appear on the screen as in figure 13.
