Chapter 4 How to Use the Operator Panel
71
6
Load the documents on the hopper, start up a scanning
application, and perform a scan.
For information about the scanning procedure in ScandAll PRO, refer
to "How to Use ScandAll PRO".
D
Depending on the number of sheets scanned, it will be displayed
as follows:
Sheets
Display
Description
75
sheets
Since the count has been set to
100 in step
, it is -25 sheets.
[-] appears in the top right and
[Count] indicates “25”.
If you load additional documents
at this point, you can scan up to
25 sheets.
100
sheets
Since the count has been set to
100 in step
, it is +/- 0.
[=] appears in the top right and
[Count] indicates “0”.
110
sheets
Since the count has been set to
100 in step
, it is +10 sheets.
[+] appears in the top right and
[Count] indicates “0”. Scanning
stops once 100 sheets have been
scanned.
z
Documents may not be counted correctly if a multifeed
occurs during scanning.
z
In the following cases, the scanning returns to normal
from Doc Count Check mode:
- When you only scan the specified pages (selecting
[Scan the specified number of pages] in [Scan
Settings] of ScandAll PRO)
- When you scan using a Job Separator
z
When you press the [Counter Reset] button, the
screen returns to [Doc Count Check Mode] in step
.
z
When you press the [Stop] button, it exits [Doc Count
Check Mode] and returns to the [Ready] screen.
