Chapter 1 Scanner Overview
23
If there are only a few documents, you can set the hopper to a
higher position and shorten the time to get to the feeding
position.
This function is only available when [Ready] is displayed on
the operator panel LCD.
The hopper level can be set for three different capacities.
*1: For documents with a paper weight of 80 g/m
2
(20 lb).
The capacity varies depending on the paper weight of the document.
For more details, refer to
"2.2 Documents for Scanning" (page 40)
.
Use the operator panel to adjust the height of the hopper.
Configure by selecting [10: Hopper Level] in the [Main Menu]
of the operator panel.
For more details about the settings, refer to
.
When the scanner has just been powered on, it is set to the [4:
Lower] position.
1.7 Setting the Loading Capacity of the Hopper
z
To avoid the risk of jamming your fingers, do not touch the
hopper while it is moving up/down.
z
Do not place anything on top of the hopper while it is
moving. The scanner may be damaged if any object is
caught inside.
z
To avoid any contact that may damage the scanner, do not
place anything beneath the hopper.
z
Do not adjust the hopper height from the operator panel
when the hopper is closed, as it may damage the hopper.
Upper:
A maximum of 100
sheets (*1) can be
loaded.
Middle:
A maximum of 300
sheets (*1) can be
loaded.
Lower:
A maximum of 500
sheets (*1) can be
loaded.
Lower
Middle
Upper
[Hopper Level] can also be displayed by shortcut key. To
display the [Hopper Level] screen by shortcut key, press the
[Eject] button and either [
U
] or [
V
] button at the same time
when [Ready] is displayed. Change the hopper level by using
the [
U
] or [
V
] button in [Hopper Level]. Note that the [Hopper
Level] screen is not displayed unless the two buttons are
pressed simultaneously.
When [Hopper Level] is displayed by shortcut key, the screen
returns to [Ready] after a certain period of time. This period of
time can be configured in [18: Operation Panel Timeout] of the
operator panel.
Function
/Enter
Check
Menu
Scan
Stop
Eject
Counter
Reset
iMFF
Send to
/Pause
Clear
/Back
