2-3
bizhub PRESS C1100/C1085
2
Contents of both sides adjustment items
This section describes the contents of the following six adjustment items.
-
Placing paper (
Page 2-3
)
-
Front side adjustment (
Page 2-6
)
-
Gap adjustment (When not using PF-708 scanner) (
Page 2-11
)
-
Scan measurement adjustment (When using PF-708 Scanner) (
Page 2-16
)
-
Registering the paper profile (
Page 2-24
)
-
Back side fine adjustment (
Page 2-26
)
)
Placing paper
1
Pull out the tray to load paper into.
NOTICE
Trays can be pulled out only when this machine is turned
on. Before pulling out the target tray, check that the sub
power switch is turned on.
2
Turn the side guide lock knobs (2 pieces)
counterclockwise to loosen them.
3
Widen the side guide plates on both
sides with pressing the side guide lock
release lever (
).
NOTICE
To slide the side guide plates, be sure to hold both side
guide plates together. If you move it by holding only either
of the side guide plate, the side guide plate that is held
may become displaced.
4
Widen the rear guide plates on both
sides with pressing the rear guide lock
release lever.
5
Load an appropriate amount of paper into the tray while aligning it to the left-hand side
of the tray.
NOTICE
Load paper with the print side facing up.
Summary of Contents for bizhub PRESS C1085
