Konica Minolta 7075/FORCE 75, Service Manual

Page: 452 / 844

1 - 110
OTHER ADJUSTMENT
1 - 109 - 1
[2] Paper Feed Roller Load Adjustment
(7085 main body tray only)
Caution: This adjustment is required when no
feed of paper occurs.
1. Tool
• Screwdriver (Phillips)
2. Paper feed roller load adjustment on trays
1, 2, 3
Screws
Weight plate
Step Operation
1 Pull out the tray.
2 Use two screws to install the weight plate
on top of the paper feed holder plate.
3 Chek the pick-up release amount. See
[7] Pick-up Release Amount Adjustment.
4 Set the tray and run a test copy to check
the paper feed status.
5 When "no feed" is not solved, add more
weight plates and repeat steps 1 to 4.
Caution: Up to 6 weight plates (P/N:56GA4242*)
can be installed. The M3 x 6 mm screws
must be used to install up to three weight
plates, and the M3 x 8 mm screws must
be used when four to six plates are
installed.
a. Adjustment Method
3. LCT paper feed roller load adjustments
(LT-411/412 only)
Screws
Spring
Weight plate
Step Operation
1 Open the top cover.
2 Remove the spring.
3 Use two screws to install the weight plate
on top of the paper feed roller.
4 Chek the pick-up release amount. See
[7] Pick-up Release Amount Adjustment.
5 After installing the spring and closing the
top cover, run a test copy to check the
paper feed status.
6 When "no feed" is not solved, add more
weight plates and repeat steps 1 to 5.
Caution: Up to 6 weight plates (P/N:13FG4062*)
can be installed. The M3 x 6 mm screws
must be used to install up to three weight
plates, and the M3 x 8 mm screws must
be used when four to six plates are in-
stalled.
3
METHOD
REPLACEMENT
MODEL
7075/7085
MANUAL
SERVICE HANDBOOK
REVISED EDITION
3
DATE
Jan. 2002
PAGE
1-109-1
a. Adjustment Method
Paper feed holder plate
3
3