Konica Minolta 7075/FORCE 75, Service Manual

Page: 769 / 844

E-3
5. Confirmation of the Memory Capacity
(1) Plug the power cord to the outlet.
(2) Turn the Main switch ON pressing the ten key
[4] and [7] simultaneously. (Enter the 47 mode.)
(3) Press the ten key [9] and then [7]. (Select the
cord 97.)
(4) Press the copy button.
The memory capacity for the RDH is recognized
automatically and displayed on the operation
panel of the console as like.
(5) Confirm the conformity between the gross
capacity of the memory displayed on the panel
and the installed one.
(6) Turn the Main switch OFF.
[Konica 7155/7165]
1. Turn the Main switch OFF, and unplug the power
cord from an outlet.
2. Remove the IP-511 from the main body, if installed
in it.
3. Remove the rear cover. (6 screws)
Rear cover
4. Remove the Control board cover. (6 screws)
Control board cover
5. Install the Memory unit on the Control board slot.
Caution:
• Install the Memory unit meeting its cutout
properly to the slot on the Control board.
• On the installation, open both clamps of the slot,
and insert the Memory unit, tilting for 45 degrees
against the Control board, until clicking the
clamps.
6. Reinstall the removed parts in the reversed
procedure.