Kongsberg Simrad EK80, Installation Manual

Page: 231 / 354

394149/D
229
and the sensor is connected, you must define the datagram priority and finalize the
configuration.
Note
Just making changes and selecting
OK
at the bottom of the page will not install anything.
Select what to install, define the relevant parameters, and then select
Add
.
Procedure
1 Open the
Setup
menu.
2 On the
Setup
menu, select
Install
.
Observe that the
Installation
dialog box opens. This dialog box contains a number
of pages selected from the menu on the left side.
3 Set up the interfaces to the navigation sensors.
a On the left side of the
Installation
dialog box, select
I/O Setup
.
b Set up the relevant serial or Ethernet (LAN) communication parameters.
c At the bottom of the page, select
Apply
to save your settings.
d On the left side of the
Installation
dialog box, select
Sensor Installation
.
e Select the type of sensor you want to interface, and define the relevant
parameters.
f Select
Add
to save the new sensor interface you have defined.
g On the left side of the
Installation
dialog box, select
Sensor Configuration
.
h Define the priority of the datagrams, and set up relevant configuration
parameters.
i At the bottom of the page, select
Apply
to save your settings.
4 Repeat for each sensor interface that you need to set up.
5 Continue your work in the
Installation
dialog box, or select
OK
to close it.
Related topics
Interfacing peripheral equipment, page 228
Setting to work