Kongsberg Flexview, Installation Manual

Page: 89 / 126

922-20207011/1.0
87
Procedure
1 Click
Setup
→
Connect
to start the Sonar Head.
Make sure that a sonar image appears in the sonar view window.
2 Click the “i” icon in the top-left corner of the sonar view to open the
Information Widget
.
Make sure that the sensor data is updating in the
Information Widget
.
3 Make sure that no errors are displayed in the
Output
Messages
window.
a Click
Display
→
Output Messages Window
.
b Make sure there are no errors shown in the
Output
Messages
window under the
Host Messages
or
Head
Messages
tab.
4 Make sure there are no errors in the
Connection Status
and
Head Status
windows.
a Click on the text “Active” located in the
lower-right corner of the status bar.
Observe that the
Connection Status
window opens.
b Make sure that all items listed under the FlexviewSonar show check marks.
If any items are shown with an “X” in a red circle, it usually means the device has
failed to connect. Disconnect and make sure that no sensors have failed.
c Click on the top line in the
Connection Status
window.
Setting to work