Komatsu Utility 69001, Operation & Maintenance Manual

Page: 190 / 276

RECOMMENDED FUEL, COOLANT, AND LUBRICANT
MAINTENANCE
4-12
RECOMMENDED FUEL, COOLANT, AND LUBRICANT 4
q
Komatsu genuine oils are adjusted to maintain the reliability and durability of Komatsu construction equipment
and components.
In order to keep your machine in the best conditioner for long periods of time, it is essential to follow the
instructions in this Operation and Maintenance Manual.
q
Failure to follow these recommendations may result in shortened life or excess wear of the engine, power
train, cooling system, and/or other components.
q
Commercially available lubricant additives may be good for the machine, but they may also cause harm.
Komatsu does not recommend any commercially available lubricant additive.
q
Use the oil recommended according to the ambient temperature in the chart below.
q
Specified capacity means the total amount of oil including the oil in the tank and the piping. Refill capacity
means the amount of oil needed to refill the system during inspection and maintenance.
q
When starting the engine in ambient temperatures below 0°C, do not use EO30DH, even if the daytime tem-
perature rises to 10°C. Always use multigrade oil such as the recommended EO10W30DH or EO15W40DH.
q
If the machine is operated at a temperature below -20°C, a separate device is needed, so consult your
Komatsu distributor.
q
When the fuel sulfur content is less than 0.5%, change the engine oil according to the period inspection table
given in this Operation and Maintenance Manual.
q
If the fuel sulfur content is more than 0.5%, change the oil according to the following table.
NOTE: Only use Komatsu genuine engine oil.
* If using these fuels, serious troubles may occur because of early deterioration of engine oil or early wear of
engine internal parts. If using them by necessity for local situations, be sure to inform customers about the follow-
ing.
1) Be sure to check Total Basic Number (TBN) of oil frequently by TBN handy checker etc., and change oil based
on the result.
2) Always be aware that oil change interval is extremely shorter than standard.
3) Be sure to carry out periodic engine inspection by distributor's expert since change interval of periodic replace-
ment parts and overhaul interval are also shorter.
For details refer Note 1 at the end of this chaper.
Sulphur content (%) Oil change interval
Less than 0.5 500 hours
0.5 ~ 1.0 250 hours
Above 1.0 Consult Komatsu Distributor