Kohler KD83V16, Service And Repair Manual

Page: 291 / 300

Service and Repair Manual Appendix
Standard tightening torques
Size Tightening torque Size Tightening torque
1)
VSTI ED VSTI o-ring
1)
VSTI ED VSTI o-ring
M60x2 - 400 Nm
295 ft-lb
- - -
Tab. 77: VSTI screw plug tightening torques for aluminium parts
1)
Do not use hydropneumatic screwdriver.
5.3.11 Assembling pipes with DKO connectors (EL, ET, EW, GZ, GZR,
RED)
Fig. 352: DKO connector
Fig. 353: DKO connector lubrication
Information
Tolerances of the indicated tightening torques: 10 %.
Always lubricate the thread before tightening these parts (engine oil).
Information
To assemble pipes with DKO connectors, observe the following steps:
u
When tightening the nut, make sure the connector does not rotate.
u
Tighten the nut by hand.
u
Hold a wrench as close as possible to the nut.
u
Tighten the nut with the wrench until the resisting point.
u
Tighten the nut a further 90°.
Alternatively, refer to the following table for tightening sequence of the nut:
Size Equivalent specification Size Equivalent specification
06L 20 Nm
15 ft-lb 06S 25 Nm
18 ft-lb
KD83V16 33525088901_2_1 EN_US
2021-07
© 2021 by Kohler Co. All rights reserved.
291