Kodak dryview 8300, Service Manual

Page: 37 / 332

INSTALLATION INSTRUCTIONS
2-19
2004 December Rev.S 1908110
Table 2-5. Setting the Network Installation Parameters
Parameter Options Action
1. ASPECT RATIO 0.50 to 2.00 Set to 1.0, which checks that the
pixel aspect ratio values
communicated through DICOM
are correct. After acquiring a first
image, changes to this value
may be necessary.
4. NETWORK INTERFACE
1. ADDR
None (MAC Address)
Do not change. Leave at default
value.
2 IP ADDRESS SOURCE Local or RARP server. Use the menu instructions to
indicate if the address is entered
locally, or automatically by a
RARP server.
3. IP ADDR Assigned by customer. Use the menu instructions to
enter the IP address provided by
the customer’s network
administrator. If one is not
provided, set the address source
to RARP in menu item 2.
4. NET MASK Assigned by customer. Use the menu instructions to
enter the Net Mask provided by
the customer’s network
administrator. The value is
entered in decimal format where
255 decimal = FF hexadecimal. If
the customer uses hexadecimal,
FFFFFF00 would =
255.255.255.0.
5. CONNECTOR 10BaseT Use the menu instructions to
select 10BaseT modular Telco
type CONNECTOR only. A BNC
connection is currently not
available.
6. ROUTER Assigned by customer, if
required.
Enter the Router Address
provided by the customer’s
network administrator.
This parameter is the gateway to
other subnets, and might be
necessary if the MODALITY is
not located on the same subnet
as the IMAGER.