Kodak dryview 8300, Service Manual

Page: 198 / 332

SERVICE MANUAL
7-30
1908110 2004 December Rev. S
7-2-7. EC22: Remove Misfeed From Exposure Area
LOCAL PANEL Message Host Alarm Service Log
REMOVE MISFEED FROM EXPOSURE AREA.
INSERT FILM SAVER TO REMOVE FILM TRAY
Yes Yes
SUMMARY
Film is stuck in the CAPSTAN area and the MEDIA SENSE SWITCH (at CAPSTAN) is being held
de--actuated.
SEQUENCE OF EVENTS
•
When a print is requested, the CAPSTAN STEPPER MOTOR will energize.
•
Film is moved up to the CAPSTAN ROLLERS by the SEPARATION/PROCESSOR STEPPER MOTOR.
•
When the film enters the CAPSTAN ROLLERS, the lower ROLLER shifts and causes a mechanical
linkage to deactuate the MEDIA SENSE SWITCH (at CAPSTAN).
PHONE FIX -- OPERATOR CORRECTABLE
1. Insert the FILM SAVER and remove the FILM TRAY.
2. Raise the COVER and remove film from exposure area.
3. Be sure the UPPER FILM GUIDE is latched into position.
4. Close the COVER and install the FILM TRAY.
5. Remove the FILM SAVER and press [Enter] to continue.
ON SITE --TECHNICIAN CORRECTABLE
Problem
-- Film is being sensed constantly by the MEDIA SENSE SWITCH (at CAPSTAN).
Solution -- Check the functionality of the CAPSTAN MOTOR. Perform the MEDIA SENSE SWITCH (at
CAPSTAN) adjustment, if necessary.
Problem -- The film jams at the PROCESSOR ENTRANCE GUIDES because these GUIDES do not line
up properly with the UPPER FILM GUIDE.
Solution -- Adjust the PROCESSOR mounted position so that the PROCESSOR ENTRANCE GUIDES are
in proper alignment with the UPPER FILM GUIDE.
TECH TIPS
To check SWITCH functionality:
1. Open the TOP COVER and defeat the COVER INTERLOCK.
2. Put the IMAGER in a Ready Condition so it is warming up with the FILM TRAY inserted and filmsaver
only partially removed.