Kodak dryview 8300, Service Manual

Page: 24 / 332

SERVICE MANUAL
2-6 1908110 2004 December Rev. S
Table 2-2. Setting the Digital Installation Parameters
Parameter Options Action
1. ASPECT RATIO 0.50 to 2.00 Set to 1.0. After acquiring a first image,
changes to this value may be necessary.
Adjust this parameter to what is displayed on
the MONITOR of the MODALITY. If a circle or
square test pattern cannot be displayed on the
MONITOR, ask the operator to make a square
or rectangle with the characters from the
KEYBOARD of the MODALITY.
(Note: The “clocks per line” parameter must be
set correctly before you set up Aspect Ratio.)
Measure the sides of the square or rectangle
on the MONITOR and compare these values to
what is on the film. The ratio should be the
same. A value of .9 is normal for many
Ultrasound MODALITIES.
Note
If “3M protocol” is selected, options 1--4 of the Serial Control Interface are available.
3. SERIAL CONTROL
INTERFACE:
For settings:
1. BAUD RATE 1200, 2400, 4800,
9600, or 19200
Select between baud rates.
2. NUMBER OF DATA BITS 7 or 8 Select data bit settings for value.
3. NUMBER OF STOP BITS 1 or 2 Select stop bit setting for value.
4. PARITY ODD, EVEN, or
NONE
Select parity setting between selections.
5. DELIMITER Comma or space. Select between options, for host requirements
to separate DZO commands.
6. IGNORE LATE ACK/NAK ON or OFF. Set to ON if the host device is a Kodak PACS
Link 9410 ACQUISITION SYSTEM.
7. PROTOCOL 3M (Host) or
KEYPAD
Select the “Control Protocol” setting between
options.
6. MARK INSTALL DATE Date of install:
day/month/year If date is incorrect, change Date/Time
parameter in the “General Setup” menu.
7. MEMORY MANAGEMENT A = 4.0 MB
B = 4.0 MB Partition memory across 2 INPUT MODULES
as necessary. If using only 1 MODULE, all
memory should be set to that input. See
paragraph 2--6 for setting up memory.