KNS Ku-BAND RX, Installation And Operation Manual

Page: 39 / 123

31
3.6.3.6 M&C Port Connection
Use the M&C port when monitoring and configuring the antenna using the PC and SCS
ver 1.7.2 This requires the installation of a serial cable or Mini USB-to-Serial cable for
communication between the two devices. Remember that the baud rate of the M&C Port is
fixed at 57600.
M&C DB-9 Pin No. Type
2 Receive Data
3 Send Data
5 GND
All other pins NA
Table 3-9 Layout of M&C Port Pins
3.6.3.7 Ethernet Port
Both installer and operator can access to the ACU from outer devices using the Ethernet.
You must configure the host IP address, gateway, and subnet-mask to use the Ethernet.
We provide remote access software (SCS V1.7.2 & TMonitor) to the dealer. If you wish to
obtain this software, please contact us.