25
isolated from any other groundings due to the sensitivity of the CMOS components of the
PCU.
A good rule of thumb is that the receive (RX) L-band cable be directly connected to the
antenna control unit. This is because the receive (RX) L-band cable provides the DC
power to the PCU to operate that antenna. Technically speaking, the grounds from the
TX and RX IFL runs can be different, but a single piece of cable running from the ACU to
the antenna will ensure that the antenna operates properly and protect it from a possible
48 VDC, which supports the optional BUC installation.
Refer to Figures 3-23 and 3-24 below for a simplified block diagram of the different sizes
of BUC installations.
Figure 3-23 ACU Cable Connection (BUC Capacity: Modem supplies the BUC Power)
Summary of Contents for Ku-BAND RX
