Suspension Arm Systems Independant
Revision 1
93
8.5
Correcting the Vertical Alignment of the M6 Service Head
After the installation of an end device, the shelf of the M6 service head may not perfectly
vertical due to the weight of the end device.
Opening the lower casing on the rear
•
Observe the safety notice, see section 8.1
“Safety Notice for Adjustment Work”,
page 86.
•
Successively press a suitable screwdriver
into the 2 openings and unlock the
2 latches .
•
Fold the lower casing on the rear
downwards.
Correcting the vertical alignment
Tools to be used:
Hexagon spanner SW 4 and flat spanner SW 36.
•
Loosen setscrew M4 DIN 914.
•
Place the flat spanner on the hexagonal
bolt .
The indicator screw points downwards
(do not loosen this screw).
To lower the shelf:
•
Turn hexagonal bolt so that the indicator
screw points to the front (towards the
user).
To lift the shelf:
•
Turn hexagonal bolt so that the indicator
screw points to the rear (away from the
user).
•
Perform a function test.
•
Tighten setscrew
Fig. 8-5:
Correcting the Vertical Alignment of the M6 Service Head
