79
EN
Care and cleaning
Changing the oven light bulb
In the lamp bulb is a particularly heat-resistant mold (230 V,
25 W).
To replace this, proceed as follows:
• Disconnect in any case the device from the power
supply (pull the plug or remove the fuse), because the
wording could be live.
•
Turn off the glass cover and replace the bulb with a new
one of the same type (see figure at right).
•
Screw back the cover glass.
Removing the slide-in racks
To make it easier to clean the side walls of the cooking cham
-
ber, you can remove the slide-in racks:
•
Remove accessories such as grate and baking tray.
•
Slightly press down the slide-in rack at the clamping point (
1
)
and pull it away from the oven wall.
•
Swing the slide-in rack inwards and unhook it at the top (
2
).
Inserting the slide-in racks
•
Hook the rack into the holes at the top (
2
) and swing it
towards the side wall of the cooking chamber.
•
Slightly press down the rack bar at the clamping point (
1
)
and push the rack towards the side wall.
•
The slide-in rack must snap into place and be firmly seated.
Telescopic pull-out rails
For cleaning the slide-in racks the telescopic pull-out rails
can be removed.
•
Loosen the fixing screws with a large screwdriver and
remove the complete set.
•
Only clean the telescopic pull-out rails from the outside
with commercially available cleaning agents.
Do not immerse the telescopic pull-out rails in water or
clean them in a dishwasher!
•
After cleaning, put on the telescopic pull-out rails and fas
-
ten them again at the bottom with the screws.
Caution!
The rollers must not be greased.
!
2
1
