18
C) Playing
Load Sequence
A Sequence can be loaded by
pressing a Patch Button 1-8 while in
Sequence Mode (Arp Latch is in the
ON position). The Sequence that is
stored under the Patch button
selected will be loaded to memory
If you press the ARP button while in
Seq Mode the indicator will fast flash
and the data written into the
sequencer will be played.
The first
note of the sequence will only sound
once a clock has been received.
This
allows a seq to be queued to start.
When all the notes are played the data
will return to the beginning and be
played again from the start. Pressing
the ARP button once more (it's
indicator will slow flash) will stop
playing immediately. The tempo of the
playing will be determined by the
master clock source and the Seq
division factor. If the clock source is
the Internal Clock then the Master
Clock tempo will be set by the Poly Six
SPEED knob. The SPEED Knob will
have no effect if the clock source is
midi clock.
* If you stop the Sequence part
way through and then restart it
the data will start from the
beginning.
* If you wish to only play the data
once, put some rests are the
end so it is easier to stop the
sequence in the correct place.
The clock for the Sequencer is
divided from the Master Clock. The
Seq Clock Divider parameter is
located under POLY button and
adjusted using the FX Rate knob
while in Seq Mode.
A sequence playing will follow the
same key transpose that is set in the
KiwiSix. By starting a sequence and
then switching to SHIFT mode by
turning on the TAPE switch it will be
possible to shift a playing seq
transpose.
If the HOLD button or pedal is
pressed (with the hardware mod
done) then any played notes will hold
but not seq notes. This can be useful
for playing along with a sequence.
www.kiwitechnics.com
KiwiSix Upgrade User Manual v3
