10
E
N
15.2 -
Activating/deactivating start and pedestrian security mode
Default = wired start input and start button of the control unit are activated.
This programming sequence allows for better security by disabling the operation of the “start” / “ped” wired input and the start button on
the control unit. T
h
e control unit is now activated with the transmitter only.
1.
PRESS THE
START
BUTTON
FOR 4 SECONDS
3 LEDs turn on and then all LEDs turn off
(if not, consult Paragraph 16.1)
2.
PRESS THE
SET
BUTTON FOR 1 SECOND:
If the red “error” LED is on
security = activated
(if the setting is correct, go to Point 5; if not, pro
-
ceed to Point 3)
If the red “error” LED is off
security = deactivated
(if the setting is correct, go to Point 5; if not, pro
-
ceed to Point 4)
The yellow “set” LED turns on
lock
deactivation
lock
activation
3.
PRESS THE “
START
” BUTTON
FOR 1 SECOND
5.
PRESS THE
SET
AND
RADIO
BUT-
TONS SIMULTANEOUSLY OR WAIT 10
SECONDS TO EXIT THE PROCEDURE
4
PRESS THE “
START
” BUTTON
FOR 1 SECOND
The yellow “set” LED remains ON and the
red “error” LED turns off
The LEDs return to the normal operation
configuration
The yellow “set” LED remains ON and the
red “error” LED turns on
If the
security
command lock is activated, any device connected to the “start” and “ped” contacts will not be detected by
the control unit. When these contacts are closed, the green “start” LED will emit brief flashes.
16.
Other functions
To interrupt the following programming sequences at any time, press the SET and RADIO buttons simultaneously or wait
10 seconds.
16.1 -
Activating/deactivating the control unit protection device
Default = control unit protection device not active.
This programming sequence allows for locking all control unit programming sequences and the settings adjustable through
the dip-switches. To perform a new programming sequence or make a dip-switch/trimmer modification effective, the protec
-
tion must be deactivated.
If the yellow led “set”, the red led “radio” and
green led “start” are ON:
central unit lock = enabled
(if it is the correct setting, go to step 5, otherwise
proceed to step 3)
If the yellow led “set”, the red led “radio” and
green led “start” are OFF:
central unit lock = disabled
(if it is the correct setting, go to step 5, otherwise
proceed to step 3)
Enabling control
unit setup
Disabling control
unit setup
FOR 3
1.
PRESS
THE
S
T
AR
T
BUTTON
SECONDS
