11
E
N
If the operator does not recognise the mechanical stops (end of the travel for swing gates) even with the OBS knob set to
its minimum, you can select the open and closed points during programming by pressing the “SET” button
(or a programmed
transmitter’s button)
at the end of points 5, 6 and 7. In the event of two gate leaves, use the “SET” button for both leaves.
The red ERROR LED
flashes
during travel and at the end of travel points. This occurs when the motor is using high
current. It is normal for the error light to
fl
ash brie
fly
during travel. If the error light up longer than brief interval then
increase the obstacle dial and check again. ( make sure you have enough force with the obstacle adjustment so the gate will
not stop in winds.
5.2 -
Programming the pedestrian (partial) opening width
This procedure allows to change the default pedestrian opening gap.
Default opening settings:
- swing gates: Motor 1 fully open
- sliding gate: 30% of the total travel
To control the pedestrian opening, it is necessary to either program a radio control button (see Paragraph 4.2) or connect a wired control
device on the “PED” contact (see Paragraph 2.2).
Prior to proceeding with this programming procedure, make sure that either basic programming or advance programming
.
d
e
t
e
l
p
m
o
c
n
e
e
b
e
v
a
h
l
e
v
a
r
t
e
t
a
g
e
h
t
f
o
1.
CLOSE THE GATE FULLY
2.
PRESS THE
SET
BUTTON
FOR 2 SECONDS
3.
PRESS THE
START
BUTTON
FOR 1 SECOND
(if not, consult Paragraph 16.1)
6.
PRESS THE START BUTTON OR A
PROGRAMMED TRANSMITTER
BUTTON
5.
THE GATE STARTS TO OPEN
4.
PRESS THE
START
BUTTON OR
A PROGRAMMED TRANSMITTER
BUTTON
7.
THE GATE STOPS THE
MANEUVER AND CLOSES FULLY
8.
END OF THE PROGRAMMING
PROCEDURE
The yellow “set” LED turns off
The LEDs return to the normal
LEAF 1
(gate leaf that opens first,
connected to “MOTOR 1”)
LEAF 2
,
d
n
o
c
e
s
s
n
e
p
o
t
a
h
t
f
a
e
l
e
t
a
g
(
connected to “MOTOR 2”)
6
The yellow “set” LED stays on
The yellow “set” LED stays on
The yellow “set” LED stays on
The yellow “set” LED turns on
The yellow “set” LED flashes
