12
E
N
5.3 -
Advanced programming of the gate travel
path
With this procedure, you will set the slow down points or remove them completely
1.
PUT THE GATE LEAF/LEAVES
TO TO ABOUT HALF WAY PO-
SITION
2.
PRESS THE
SET
BUTTON
FOR 2 SECONDS
3.
PRESS THE
RADIO
BUTTON
FOR 1 SECOND
The yellow “set” LED flashes
(if not, consult Paragraph 16.1)
The yellow “set” LED turns on
in the fixed mode
7.
PRESS THE
SET
BUTTON OR A
PROGRAMMED
TRANSMITTER
BUTTON
6.
THE GATE MOVES TO
FULL CLOSING POSITION
4.
THE GATE PARTIALLY OPENS
The yellow “set” LED flashes
5.
THE SYSTEMS PAUSES FOR
APPROX 8 SECONDS
The yellow “set” LED stays on
The yellow “set” LED stays on
The yellow “set” LED flashes
8.
THE GATE PERFORMS AN
OPENING MOVEMENT
9.
PRESS THE
SET
BUTTON, OR A PROGRAMMED
TRANSMITTER
BUTTON, TO SET
THE SLOWDOWN START POINT. TO CANCEL THE SLOWDOWN POINT, JUST WAIT FOR
THE GATE TO FINISH THE MANOUVER
The yellow “set” LED stays on
The yellow “set” LED stays on
12.
THE GATE CLOSES
11.
PRESS THE
SET
BUTTON OR A PROGRAMMED
TRANSMITTER
BUTTON
10.
THE GATE COMPLETES
THE OPENING PHASE
The yellow “set” LED stays on
The yellow “set” LED stays on
The yellow “set” LED stays on
13.
DURING MOVEMENT: PRESS THE
SET
BUTTON OR A PROGRAMMED
TRANSMITTER
BUTTON TO SET THE SLOWDOWN START POINT.
TO CANCEL THE SLOWDOWN POINT, JUST WAIT FOR THE GATE
TO FINISH THE MANOUVER
14.
THE GATE IS NOW FULLY CLOSED
AND SETUP IS COMPLETE.
The yellow “set” LED stays on in the fixed mode
The yellow “set” LED turns off
