10
EN
5.
Programming the gate travel path
1
23
45
6
78
1
2
3
4
5
6
7
8
E
RR
O
R
S
TOP
PH
O
TO
S
TA
R
T
RADIO
S
E
T
1.
MOVE THE GATE TO ABOUT
HALF WAY POSITION
2.
HOLD THE
SET
BUTTON
FOR APPROX 4 SECONDS
3.
IMMEDIATLY RELEASE THE
S
ET
BUTTON
The yellow “set” LED will turn on
and the gate will start moving
The gate will now start the
setup proceedure
6.
THE GATE PERFORMS
A FULL OPENING MOVEMENT
5.
THE GATE PERFORMS
A FULL CLOSING MOVEMENT
4.
THE GATE PERFORMS
A PARTIAL OPENING MOVEMENT*
7.
THE GATE PERFORMS
A FULL CLOSING MOVEMENT
8.
END OF THE PROGRAMMING
PROCEDURE
The yellow “set” LED turns off
The LEDs return to the normal
N
E - if the automation starts a closing stroke instead of an opening stroke, proceed as follows:
1. quit programming by pressing SET and RADIO simultaneously:
for SWING GATE MOTORS: swap the motor phases (terminals MOT1, MOT2) and the inputs of any limit switches (terminals
10-11, 13-14) for SLIDING GATE MOTORS: change the setting of DIP8, see par. 3.1. Alternatively, swap motors’ direction
through the KING SPECIALIST APP.
2. reprogram the stroke from point 1.
5
Knob
Power
Start button
Set button
Radio button
Initial basic setup of the gate travel must be done prior to using the gate
-
tion has been activated – see Paragraph 16.1.
To interrupt the following programming sequences at any time, press the SET and RADIO buttons simultaneously or wait
10 seconds.
In this procedure, the control unit will learn the gate travel time and force to determine a default slowdown point. This procedure is
sufficient for most installations. To cancel or change slowdown points see section 5.3.
The yellow “set” LED stays on
The yellow “set” LED stays on
The yellow “set” LED stays on
5.1 -
Basic programming of the gate travel pass
