6
EN
IF THE “AUX” OUTPUT IS SET AS COURTESY LIGHT
(see Paragraph 13.2)
Default = monostable
When a command is received from a transmitter pulse, it is possible to set the AUX contact work mode as:
MONOSTABLE: after every radio command, the control unit closes the contact for 3 seconds.
BISTABLE, ON/OFF: after every radio command, the control unit changes the status from open to closed.
3 LEDs turn on and then all LEDs turn off
(if not, consult Paragraph 16.1)
2.
PRESS THE
RADIO
BUTTON FOR 1 SECOND:
If the green “stop” LED is on
AUX = Monostable intermediate
(if the setting is correct, go to Point 5; if not, pro-
ceed to Point 3)
If the green “stop” LED is off
AUX= Bistable (ON/OFF) latch
(if the setting is correct, go to Point 5; if not, pro-
ceed to Point 4)
The red “radio” LED turns on
AUX = Bistable
setting
AUX = Monostable
setting
3.
PRESS THE “
RADIO
” BUTTON
FOR 1 SECOND
5.
PRESS THE
SET
AND
RADIO
BUT-
TONS SIMULTANEOUSLY OR WAIT 10
SECONDS TO EXIT THE PROCEDURE
4.
PRESS THE “
RADIO
” BUTTON
FOR 1 SECOND
The red “radio” LED remains ON and
the green “stop” LED turns off
The LEDs return to the normal operation
The red “radio” LED remains ON and
the green “stop” LED turns on
To control the AUX contact set as courtesy light, a radio command must be registered through the procedure indicated in
Paragraph 13.1 and connect a suitable relay (see paragraph 13).
13.4 -
Selection of “AUX” output voltage (only for STARG8 24)
STARG8 AC (FIXED VOLTAGE OF 12V AC)
STARG8 24: Default=12VDC
The output voltage of the AUX contact can be set to 12VDC or 24VDC, depending on the connected lock or the available relay.
All LEDs turn off
(if not, consult Paragraph 16.1)
2.
PRESS THE
RADIO
BUTTON FOR 1 SECOND:
If the red “error” LED is on
AUX voltage = 12VDC
(if the setting is correct, go to Point 5;
if not, proceed to Point 3)
If the red “error” LED is off
AUX voltage = 24VDC
(if the setting is correct, go to Point 5;
if not, proceed to Point 4)
The red “radio” LED turns on
AUX = 24VDC
setting
AUX = 12VDC
setting
3.
PRESS THE “
START
” BUTTON
FOR 1 SECOND
5.
PRESS THE
SET
AND
RADIO
BUT-
TONS SIMULTANEOUSLY OR WAIT 10
SECONDS TO EXIT THE PROCEDURE
4.
PRESS THE “
START
” BUTTON
FOR 1 SECOND
The red “radio” LED remains lit and the
red “error” LED turns off
The LEDs return to the normal operation
The red “radio” LED remains lit and the
red “error” LED turns on
SECONDS
SECONDS
1.
PRESS
THE
START
BUTTON
FOR 3
1.
PRESS
THE
START
BUTTON FOR 3
