5
EN
13.2 -
Selection of device connected to “AUX” output
Default = electric lock 12V
This procedure allows for setting the “AUX” output for the operation as:
ELECTRIC LOCK: the control unit closes the AUX contact (terminals 3-4) whenever a command is received.
By default the contact is closed for 2 seconds (electric lock mode ). To change the work mode, see Paragraph 13.3.
COURTESY LIGHT: the control unit closes the AUX contact (terminal 3-4) whenever a radio command is received (the AUX button must be
programmed – see Paragraph 13.1). By default the command is monostable. To change the work mode, see Paragraph 13.3.
To control the AUX output when it has been set as a courtesy light output, you need to register a transmitter by following
the procedure in paragraph 13.1 and connect a suitable relay.
SECONDS
3 LEDs turn on and then all LEDs turn off
(if not, consult Paragraph 16.1)
2.
PRESS THE
RADIO
BUTTON FOR 1 SECOND:
If the green “photo” LED is on
AUX = lock
(if the setting is correct, go to Point 5; if not, pro-
ceed to Point 3)
If the green “photo” LED is off
AUX = switching (Courtesy light)
(if the setting is correct, go to Point 5; if not, pro-
ceed to Point 4)
The red “radio” LED turns on
courtesy light
setting
electric lock
setting
3.
PRESS THE “
SET
” BUTTON FOR
1 SECOND
5.
PRESS THE
SET
AND
RADIO BUTTONS
SIMULTANEOUSLY OR WAIT 10 SECONDS
TO EXIT THE PROCEDURE
4.
PRESS THE “
SET
” BUTTON FOR
1 SECOND
The red “radio” LED remains ON and
the green “photo” LED turns off
The LEDs return to the normal operation
The red “radio” LED remains ON and
the green “photo” LED turns ON
13.3 -
Selection of “AUX” as lock output electric or magnetic
WHEN THE “AUX” OUTPUT IS SET AS LOCK
(see Paragraph 13.1)
Default = electric lock
The work mode (i.e. how the contact behaves at every wired or radio START command) can be set as:
ELECTRIC LOCK: at every command, the control unit closes the contact for 2 seconds
MAGNETIC LOCK: the control unit closes the contact only when the automation is fully closed
3 LEDs turn on and then all LEDs turn off
(if not, consult Paragraph 16.1)
2.
PRESS THE
RADIO
BUTTON FOR 1 SECOND:
If the green “stop” LED is on
AUX = Electric lock
(if the setting is correct, go to Point 5;
if not, proceed to Point 3)
If the green “stop” LED is off
AUX = Magnetic lock
(if the setting is correct, go to Point 5;
if not, proceed to Point 4)
The red “radio” LED turns on
magnetic lock
setting
electric lock
setting
3.
PRESS THE “
RADIO
” BUTTON
FOR 1 SECOND
5.
PRESS THE
SET
AND
RADIO
BUT-
TONS SIMULTANEOUSLY OR WAIT 10
SECONDS TO EXIT THE PROCEDURE
4.
PRESS THE “
RADIO
” BUTTON
FOR 1 SECOND
The red “radio” LED remains ON and
the green “stop” LED turns off
The LEDs return to the normal operation
The red “radio” LED remains ON and
the green “stop” LED turns on
1.
PRESS
THE
START
BUTTON FOR 3SECONDS
1.
PRESS
THE
START
BUTTON FOR 3
