Rhino
Robot
3
User Manual
26/32
Kinematiq SAS 2015-2020. All Rights Reserved.
Directly feeding geometry to the Grasshopper part of RhinoRobot
You can bypass the selection of curves via the interface and feed directly the Grasshopper part of RhinoRobot. For
example, you can connect your own Grasshopper definition to the R
R_Curves container linked to the ‘Frames’
cluster and then bypass the curve selection system of the interface (the RhinoRobot panel).
Customizing your toolpath
You can also very easily customize or replace the default toolpath/set of frames created by the
“Frames” cluster.
For example, you can add approach and retraction points to your toolpath as follows:
The only thing that you must continue to use
if you customize you Grasshopper definition is the “RR_Targets”
component.
This component is the one that RhinoRobot will “listen
to
” for changes and where it will load the list of targets
from, in order to simulate them via the interface.
This link betwe
en the “RR_Targets” component and the RhinoRobot interface is established when you open a
project via the “Open” button.
Summary of Contents for RhinoRobot3
Page 1: ...RhinoRobot3 User Manual...
