Kikusui TOS3200, User Manual

Page: 94 / 130

94
TOS3200
SIGNAL I/O Connector
The SIGNAL I/O connector is the D-sub 25-pin connector on the rear panel.
The connector is used to control the starting and stopping of the test or monitor the TOS3200
status.
• Connector on the TOS3200
Omron Corp. XM3B-2522 D-SUB 25-pin female connector, Screw M2.6 x 0.45
• Complies connector (plug)
D-sub 25-pin male (with fix screw M2.6)
To prevent operation errors due to noise, use a shielded D-sub 25-pin connector and a cable
of length less than or equal to 3 m.
For information on how to obtain the consumable parts, contact your Kikusui agent or distributor.
For details on how to use the tools, read the catalog by Omron.
• Wire and tool that are necessary to make the connection
SIGNAL I/O Specifications
Input signal
Low-active control input
High-level input voltage: 11 V to 15 V
Low-level input voltage: 0 V to 4 V
Low-level input current: -5 mA maximum
Input time width: 5 ms minimum
Output signal
Open drain output
Output withstand voltage: 30 Vdc
Output saturation voltage: Approx. 0.7 V (25 °C)
Maximum output current: 400 mA (TOTAL)
WARNING
Possible electric shock. Turn off all equipment before connecting or disconnecting
cables.
Wire
Single wire: ∅ 0.32 mm (AWG28) to ∅ 0.65 mm (AWG22)
Twisted wire: 0.32 mm
2
(AWG22) to 0.08 mm
2
(AWG28)
Wire stripper A wire stripper that matches the wires listed above