16
PWX
Rack Mounting
Turning the POWER switch Off
Flip the POWER switch to the ( ) side to turn the PWX series off.
The PWX series saves the panel settings (except the output on/off setting) that were in use
immediately before the POWER switch was turned off.
You can use the CONFIG settings (CF02) to select how the PWX series starts when the
POWER switch is turned on.
If the POWER switch is turned off immediately after the settings have been changed, the last
settings may not be stored.
Rack Mounting
You can use brackets or slide rails to mount the PWX series to a rack.
When you mount the PWX series to a rack, install the optional support angles (KRB1-PWX
SUPPORT ANGLE) to support the PWX series.
We recommend that you keep all pieces that you remove from the PWX series. You will need
these pieces if you remove the PWX series from the rack.
When using several PWX series power supplies together, such as for master-slave parallel
operation or series operation, mount them to a rack before use.
You can mount the PWX series to the Kikusui KRC series and KRO series racks.
See
CAUTION
After you turn the POWER switch off, wait at least 10 seconds after the panel display turns
off before you turn the POWER switch back on. Repeatedly turning the POWER switch on
and off at short intervals can cause damage to the inrush current limiter. Furthermore, this
will shorten the service life of the POWER switch and the internal input fuse.
See
Summary of Contents for PWX1500H
