Kikusui PWX1500H, User Manual

Page: 83 / 131

PWX
83
Master-Slave Parallel Operation
Parallel
/Series Operation
4
CONFIG parameters that can be set on master units
• CF00 Resets the panel settings
• CF02 Power-on status parameter
• CF04 Memory content display parameter
• CF05 CC control using an Vext or Rext
• CF06 CV control using an Vext or Rext
• CF07 CV/CC control range parameter
• CF09 External control parameter for turning output on and off
• CF10 External control logic parameter for turning output on and off
• CF12
Output-on startup state parameter
• CF14 Current setting limit
• CF15 Voltage setting limit
Starting master-slave parallel operation
Turning power on
1
Turn the master unit’s POWER switch on.
2
Turn the POWER switch of each slave unit on.
3
Operate the master unit normally.
Turn output on and off from the master unit.
Turning power off
1
Turn the slave unit’s POWER switch off.
2
Turn the master unit’s POWER switch off.
CAUTION
After you turn the POWER switch off, wait at least 10 seconds after the panel display turns
off before you turn the POWER switch back on. Repeatedly turning the POWER switch on
and off at short intervals can cause damage to the inrush current limiter. In turn, this will
shorten the service life of the POWER switch, internal input fuse, and other components.