Interface Setup
KIKUSUI Electronics Corp.
PWR-01 Interface Manual
■
LAN setting
For normal use, we recommend using the factory default settings.
Setting
Description (Factory default setting) CONFIG setting
LAN setting
Use LAN
CF40: ON
IP address allocation method DHCP: on
AUTO IP: on
MANUAL IP: off
CF61: 110
When connecting directly, for the IP address allocation method, set DHCP to off,
Auto-IP to on, and MANUAL to off (CF61: 010) to automatically set the IP address.
To set the IP address manually, for the IP address allocation method, set DHCP
to off, Auto-IP to off, MANUAL to on (CF61: 001), and set the IP address (CF62 to
CF65).
If you change the interface settings (CF61 to CF66), apply the changes (CF60:
APPL) or restart the power supply to make the new settings take effect.
For datails of CONFIG settings, see the PWR-01 user's manual.
1
Press CONFIG several times until CF40 (LAN interface setting) is dis-
played.
2
Use the CURRENT knob to select ON.
LAN is enabled.
3
Press CONFIG several times until CF60 is displayed.
4
Turn the VOLTAGE knob until CF61 (IP address assignment method) is
displayed.
5
Use the CURRENT knob to set 110.
DHCP and AUTO IP are set to on, and MANUAL IP is set to off.
6
Turn the POWER switch off and then back on to enable the settings.
■
Service request
The PWR-01 is equipped with service request and serial polling functions.
WARNING
Possible damage to the equipment and electric shock. The LAN interface
can be accessed from any place on the network. If necessary, configure
the security settings. You can apply password protection for security, and
you can restrict the IP addresses to limit the hosts.
- Note -
The LAN interface should be shifted remotely by the command. Use the "
" SCPI command to set the RS232C interface to the remote state.
Be sure to include this command at the start of the program when you are per-
forming remote programming.
