Kikusui KJM6310, Operation Manual

Page: 31 / 56

KJM6310 RS-232C Control 4-1
Chapter 4 RS-232C Control
This chapter describes remote control using the RS-232C interface.
4.1 Cable Connection and Initial Setup
Connect the 9-pin connector on the rear panel to the serial interface
connector of your PC. Use a RS-232C cross cable to make the con-
nection.
The baud rate of the KJM6310 can be set to 9
600 bps or 19 200 bps
using the switches on the rear panel. (The setting is read during power
up.)
Con
fi gure the settings on the PC to match the interface speci fi cations
below.
Baud rate 9 600 or 19 200 bps
Data length 8 bits
Parity NONE
Stop bit 1 bit
Flow control Xon/Xoff control
(Send request is ASCII 11H, and stop request is
ASCII 13 H.)
Fig.4-1 9-pin AT type connector
1: CD (carrier detect)
2: RXD (receive data)
3: TXD (transmit data)
4: DTR (data terminal ready)
5: GND (signal ground)
6: DSR (data set ready)
7: RTS (ready to send)
8: CTS (clear to send)
9: RI (ring indicator)
KJM6310 serial interface
1
2
3
4
5
6
7
8
9 1
2
3
4
5
6
7
8
9
D-sub 9 pin
Female D-sub 9 pin
Female
Cross cable example