Kikusui KJM6310, Operation Manual

Page: 16 / 56

1-4 Setup KJM6310
1.3 Precautions When Moving the KJM6310
When moving the KJM6310 to the installation location or when
transporting the unit, note the following points.
■
Always turn off the POWER switch.
Moving the KJM6310 with the power on may result in electric shock
or damage.
■
When moving the KJM6310, remove all wires that
are connected.
Moving the KJM6310 with the cables connected can cause wires to
break or injuries due to the KJM6310 falling over.
■
When transporting the KJM6310, be sure to use
the original packing materials.
If packing materials are not used, damage may result from vibrations
or from the KJM6310 falling during transportation. If you need pack-
ing materials, contact your Kikusui agent or distributor.
1.4 Connecting the DC Power Supply
Using the DC plug provided, connect a 15-V DC power supply to the
DC INPUT connector on the rear panel.
Input line voltage range 14.5 VDC to 15.5 VDC
• Be sure the polarity of the connector is correct. If the
polarity is reversed, the internal fuse will blow.
• Do not connect a power supply outside the input line
voltage range as it may cause a malfunction.
• The KJM6310 is designed to be connected to a power
supply classi fi ed as Overvoltage Category I (SELV-E).
Do not connect to a power supply classi fi ed as Over-
voltage Category II, III, or IV. For a description of the
Overvoltage Category, see “Overvoltage Category” on
page IV.
+
–
+
–
With a white line
Polarity
+ –
CAUTION
WARNING