Kikusui KJM6310, Operation Manual

Page: 25 / 56

KJM6310 Operation 3-7
Recommended setup
For the clock signal, select the edge that is synchronized to the latch
time of the RF signal sliced by the CD player, drive, etc.
• If the RF signal to be measured is already converted to one
edge, be sure to set the trigger edge of the RF signal of the
KJM6310 to rising or falling to match the signal. Measure-
ment is not possible if both edges are selected.
Fig.3-6
In the above case, set the trigger edge of the RF signal of the
KJM6310 to rising.
NOTE
RF signal
After edge conversion