KI WorkZone, Assembly Instructions Manual, Page: 33 / 36

Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
33
Tools Required
• Phillips Screwdriver
• Level
1. Set the conference end
worksurface face down onto a
soft protective surface. Attach
the single leg to the peninsula
worksurface with four #12 x 1”
screws (Figure 1).
2. Align two splice plates to the
mounting holes at the underside
of the adjoining worksurface.
Secure the splice plates to the
worksurface with four
#12 x 1” screws, two per splice
plate (Figure 2).
3. Turn the conference end
right-side-up and set it carefully
onto the splice plates of the
adjoining worksurface. Align
the mounting holes of the splice
plates with the pre-drilled holes
in the conference end. Secure
with four #12 x 1” screws, two
per splice plate (Figure 3).
4. Level the conference end
worksurface by turning the
adjustable glide on the single leg
either in or out (Figure 1).
WorkZone
®
Conference End Worksurface
Assembly Instructions
#12 x 1" screw
Tools Required
Phillips Screwdriver
Level
1. Set the conference end worksurface face
down onto a soft protective surface. Attach
the single leg to the peninsula worksurface
with four #12 x 1” screws (Figure 1).
2. Align two splice plates to the mounting
holes at the underside of the adjoining
worksurface. Secure the splice plates to the
worksurface with four #12 x 1” screws, two
per splice plate (Figure 2).
3. Turn the conference end right-side-up and
set it carefully onto the splice plates of the
adjoining worksurface. Align the mounting
holes of the splice plates with the pre-drilled
holes in the conference end. Secure with
four #12 x 1” screws, two per splice plate
(Figure 3).
4. Level the conference end worksurface by
turning the adjustable glide on the single leg
either in or out (Figure 1).
#12 x 1" screw
WorkZone Conference End Worksurface
Assembly Instructions
#12 x 1"
screw
#12 x 1"
screw
#12 x 1"
screw
single
leg
leg
leveler
splice
plates
adjoining
worksurface
adjoining
worksurface
conference end
worksurface
conference end
worksurface
Figure 1
Figure 2
Figure 3
Figure 1
Figure 2
Figure 3