26
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
WorkZone
®
Transitional Worksurface - Square/Rectangular Surface
Assembly Instructions
#12 x 1" screw
#10 x ½" screw
Tools Required
•
Phillips Screwdriver
•
Level
1. Attach two-splice plates to the
pre-drilled mounting holes under
the primary worksurface with four
#12 x 1” screws, two screws per
splice plate. Repeat the procedure
for splice plates to the return
worksurface (Figure 1).
2. To avoid scratching the
transitional worksurface, place
the top face down onto a soft
protective surface (Figure 2).
3. Position the corner leg over the
pre-drilled holes in the back
corner of the worksurface. Be
sure the modesty panel mounting
holes are oriented as shown.
Attach the corner leg to the
worksurface with four #12 x 1”
screws. Do not tighten at this
time (Figure 2).
4. Align one modesty panel to the
corner leg and worksurface
mounting holes. Insert two
#10 x ½” screws through the
modesty panel and into the
corner leg. Attach modesty panel
to worksurface with two
#12 x 1” screws. Do not tighten
at this time. Repeat this step for
second modesty panel. Tighten
all screws attaching the corner
leg and the modesty panels
(Figure 2).
Tools Required
Phillips Screwdriver
Level
1. Attach two-splice plates to the pre-drilled
mounting holes under the primary
worksurface with four #12 x 1” screws, two
screws per splice plate. Repeat the
procedure for splice plates to the return
worksurface (Figure 1).
2. To avoid scratching the transitional
worksurface, place the top face down onto a
soft protective surface (Figure 2).
3. Position the corner leg over the pre-drilled
holes in the back corner of the worksurface.
Orient the corner leg so the other four holes
of the corner leg face inward to attach the
modesty panels in a later step. Attach the
corner leg to the worksurface with four
#12 x 1” screws. Do not tighten at this time
(Figure 2).
4. Align one modesty panel to the corner leg
and worksurface mounting holes. Insert two
#10 x ½” screws through the modesty
panel and into the corner leg. Attach
modesty panel to worksurface with two #12
x 1” screws. Do not tighten at this time.
Repeat this step for second modesty panel.
Tighten all screws attaching the corner leg
and the modesty panels (Figure 2).
#12 x 1" screw
#10 x / " screw
1
2
WorkZone Transitional Worksurface
Square/Rectangular Surface
Assembly Instructions
primary
worksurface
return
worksurface
#12 x 1"
screw
splice
plates
Figure 1
Figure 2
#10 x / " screw
1
2
square
transitional
worksurface
#12 x 1"
screw
modesty panel
corner leg
#12 x 1" screw
#12 x 1" screw
adjustable
glide
Figure 1
Figure 2