KG ELS-304, Operation Manual

Page: 57 / 80

ELS-304
Programming Mode 8-3
8.3 Load Setting Commands
8.4 System Commands
Function Code Description Memo
readbak the version V readback the ROM's version
Release Alarm AC release alarm
Inrialization INI Initialize Remo condition remains
Clear CL Clear becomes the same as power ON
Response Data T0 Comma, Space
T1 Comma
T2 Space
SRQ Settings S0 None
S1 Command Error occurs
S2 Alarm Occurrs
S3 Command Error and Alarm occurs
Setup the condition to trigger the SRQ
Bound symbol of response data
Function Command Description Memo
Load Setting CC{NR2} Constant Curr.〔A〕
CR{NR2} Constant Resistor〔Ω〕
CV{NR2} Constant Volt.〔V〕
CP{NR2} Constant Power 〔W〕
Short
Curr. range is set as HIGH range
Dynamic DP{NR1} range: 0〜1 Section where DC DT and DR
1：define section "CC-1" commands are effective is defined
2：define section "CC-2"
DC{NR2} curr. value(A) in section. Effective for the section defined by
DT{NR2} time period (msec) of section. DP command
DR{NR2} set load resp. (slew rate) (A/μsec)
Curr. Setting Range RC{NR1} range : 0〜2 *1 Load current range
0： auto range
1：High range
2：Low raneg
Volt. Setting Range RV{NR1} range: 1〜2 *1 Load volt. range
1：High range This setting infludences CR and CV
2：Low raneg settings.
Output Control SW{NR1} range: 0〜1
0：load OFF
1：load ON
Load Response Setting GC{NR2} resp. time [μ/A] in CC setting Valid for CC and CV setting only.
GV{NR2} resp. time [%] in CV setting or max default value in other modes.
Curr. Limit Setting LS{NR2} Curr value[A] up to max. rated value. No limit for load curr. setting range.
Notes:
{ } : you can NOT mot in this pa NR1・・・・・・ integral value
NR2・・・・・・ real value
*1: Setting range and the meas. range of load section can not be setup independently
but should be set as identical..
Load OFF becomes no load condition
inactivating load settings.
CX{NR2}
Curr.value when ext.cont.volt is 10V
〔A〕
CS
Both mode and setting value can be
setup.
range: 0〜1
0：stop/shift dynamic operation
1： start dynamic operation
This command is to select the
Dynamic operation mode only.
Detailed Setting shall be done by
other commands below
CD{NR1}