KG ELS-304, Operation Manual

Page: 56 / 80

ELS-304
8-2 Programming Mode
8.2 Meas. Commands
Function Command Description Memo
Load curr. meas. MC{NR1} range 0〜2 *1
0：AUTO range readback value：real number（##.###）
1：curr.High range
2：curr.Low range
MV{NR1} range: 0〜2 *1
0：AUTO range readback value：real number（##.###）
1：volt.High range
2：volt.Low range
Power meas. MW Load terminal volt.×load curr. calsulated power result is back
readback value：real number（##.###）
Define meas. display DS{NR1} range: 0〜1 *2
0：define upper Meas.display
1：define lower Meas.display
Mes. Fixed mode MF{NR1} range 0〜1 meas. command selected last will be
0：free run meas. executed repeatedly.
1：single meas.
HZ{NR1} range 0〜1 sampling rate of the AD for
0：50Hz measurement can be setup.
1：60Hz
Notes
{ } : you can NOT mot in this par NR1・・・・・・ integral value
*1: Setting range and the meas. range of load section can not be setup independently
but should be set as identical..
*2: When Power switch is turned on, lower display is defined when GPIB measured (default Setting)
Display where upper or lower are
effective is define when GPIB
measured
Volt. at the load
teminal meas.
meas. frequency setting