KG ELS-304, Operation Manual

Page: 36 / 80

ELS-304
5-6 Operations of Load Modes
5.6 Constant Resistor (CR) Mode
In the CR mode, the load will act as like a constant resistor
because the Current proportional to the Load Volt flows
regardless of the Load Volt. This is the best Load mode in some
general Load Testing.
(1) Press the “rotary knob” to set mode select condition. and then turn the knob until “CR” is
displayed as shown below.
(2) Input setting value by “ten keys”, and then press “ENT” key to confirm the setting value.
(3) Press “ON/OFF” key to select ON to start flowing the load current according to this
setting.
Fig.5-6-1 Operation in CR mode
･
Confirmed values are retained if you change the load mode.
･
If you input data lower than the lower limit thereof , the lower limit value is inputted.
Supplement
I
V
Input Volt.
Load
Cuurent
Setup Resistance
7
4
1
0 .
2
5
8 9
6
3
CE
ON/OFF
ENT
Mode Select Set Value confirm Load ON
The change of a set value can be passed