Keysight Technologies U3022AH10, User'S And Service Manual

Page: 54 / 92

U3022AH10 DUT Control Lines
DUT Control Lines
The 15 pin female D-Sub connector on the front panel provides 8 latched data connections that can
be used to control your DUT or Booster Amplifier. An adjustable voltage source (+2 to +5 Vdc is
provided on the front panel. A positive or negative external source can be used. Refer to
Table 1 6
and Figure 46 on page 58 .
Setting the DUT Control Interface
This section describes how to control the DUT control lines. Refer to “Controlling the System with
N5242A /B ” on page 31 . For more information regarding the control lines, see Table 1 5 below and
Table 1 5 on page 55 .
Table 1 4 Test Set DUT Control Address and Data
Address Data Data
AD12–AD0 Description Bit Data
0= +Voltage
1= –Voltage
112 0 0000000000000 ALL DUT Control Lines set to 0 or + voltage
112 255 0000001111111 ALL DUT Control Lines set to 0 or – voltage
112 1 00000xxxxxxxB DUT Control Line 1 0,1
112 2 00000xxxxxxBx DUT Control Line 2 0,1
112 4 00000xxxxxBxx DUT Control Line 3 0,1
112 8 00000xxxxBxxx DUT Control Line 4 0,1
112 16 00000xxxBxxxx DUT Control Line 5 0,1
112 32 00000xxBxxxxx DUT Control Line 6 0,1
112 64 00000xBxxxxxx DUT Control Line 7 0,1
112 128 00000Bxxxxxxx DUT Control Line 8 0,1
Control Lines Line 8 Line 7 Line 6 Line 5 Line 4 Line 3 Line 2 Line 1
Test Set I/O Bits AD7 AD6 AD5 AD4 AD3 AD2 AD1 AD0
Bit Decimal Equivalent 128 64 32 16 8 4 2 1
Example 1 Data = 0 0 0 0 0 0 0 0 0
Example 2 Data = 21 0 0 0 1 0 1 0 1
X indicates unknown user bit state
B indicates bit of interest
To select a Test Set DUT control line configuration, all 8 DUT control lines must be set. To do this you must
add AD7 to AD0 binary number and convert this to a decimal equivalent.
54 U3022AH10 User's and Service Guide