Keysight Technologies U3022AH10, User'S And Service Manual

Page: 48 / 92

Setting Option 129 Source Path
1. Restart the PNA to Standalone Mode, if it is in Multiport Mode. Refer to Figure 2 1
on page 3 2 .
2. Send command 0.0 and [Preset] the PNA-X.
3. Refer to "Interface Control Mode" on page 41 . Use the values listed in Table 10 to
set Port 1, 3, 5, 7, 9, or 11 as the noise source path.
The test set will not operate in multiport mode. Interface or SCPI control
mode is required to set the Noise Source Path.
Table 10 Option 129 Source Path Test Set I/O Commands
Address Data Source Path
0.0 Standard Port 1
(Option 129 is not enabled)
0.8 Noise Source Port 1
0.9 Noise Source Port 3
0.10 Noise Source Port 5
U3022AH10
Controlling the System with N5242A/B
0.11 Noise Source Port 7
0.12 Noise Source Port 9
0.13 Noise Source Port 11
An 8 is added to the Data Value to activate the Option 129 switch, as
indicated in
Table 10 .
48 U3022AH10 User's and Service Guide