Keysight Technologies N69100 Series, Operating And Service Manual

Page: 27 / 260

:DELay
:FALL < value > Sets the output turn-off sequence delay.
:RISE < value > Sets the output turn-on sequence delay.
:TMODE
:COUPle 0|OFF|1|ON Couples the turn-on and turn-off settings.
[:OFF] LOWZ|HIGHZ Selects the output turn-off mode.
:ON LOWZ|HIGHZ Selects the output turn-on mode.
:INHibit
:MODE LATChing|LIVE|OFF Sets the operating mode of the remote inhibit digital pin.
:PON
:STATe RST|RCL0 Sets the output power-on state.
:PROTection
:CLEar Resets the latched protection.
:TEMPerature
:MARGin? Returns the margin remaining before the over-temperature trips.
:WDOG
[:STATe] 0|OFF|1|ON Enables or disables the I/O watchdog timer.
:DELay < value > Sets the watchdog delay time.
SENSe
:AHOur
:RESet Resets the amp-hour or watt-hour measurement to zero.
:FUNCtion
:CURRent 0|OFF|1|ON Enables/disables current measurements.
:VOLTage 0|OFF|1|ON Enables/disables voltage measurements.
:SWEep
:NPLCycles < value > Sets the measurement time in number of power line cycles.
:WHOur
:RESet Resets the accumulated watt-hour measurement.
[SOURce:]
ARB
:COUNt < value >|INFinity Specifies the number of times the Arb repeats.
:CURRent
:CDWell
[:LEVel] < value >{,< value >}| <Block> Specifies the level of each point in the Arb.
:DWELl < value > Specifies the dwell time of each point in the Arb.
:POINts? Returns the number of points in the Arb.
:FUNCtion
:TYPE CURRent|VOLTage Specifies either a voltage or current Arb.
:TERMinate
:LAST 0|OFF|1|ON Selects the output setting after the Arb ends.
:VOLTage
:CDWell
Keysight N69100 Series Operating and Service Guide 27
1 Quick Reference