Keysight Technologies N69100 Series, Operating And Service Manual

Page: 28 / 260

[:LEVel] < value >{,< value >}| <Block> Specifies the level of each point in the Arb.
:DWELl < value > Specifies the dwell time of each point in the Arb.
:POINts? Returns the number of points in the Arb.
[SOURce:]
CURRent
[:LEVel]
[:IMMediate]
[:AMPLitude] < value > Sets the output current when in current priority mode.
:TRIGgered
[:AMPLitude] < value > Sets the triggered output current.
:BWIDth
:RANGe 0|1 Sets the current compensation. Only applies to models N6914xA
:LIMit
[:POSitive]
[:IMMediate]
[:AMPLitude] < value > Sets the current limit when in voltage priority mode.
:NEGative
[:IMMediate]
[:AMPLitude] < value > Sets the current limit when in voltage priority mode.
:MODE FIXed|STEP|LIST|ARB Sets the transient mode.
:PROTection
:DELay
[:TIME] < value > Sets the over-current protection delay.
:STARt SCHange|CCTRans Specifies what starts the over-current protection delay timer.
:STATe 0|OFF|1|ON Enables or disables the over-current protection.
:SLEW
[:IMMediate] < value >|INFinity Sets the current slew rate.
:MAXimum 0|OFF|1|ON Enables or disables the maximum slew rate override.
[SOURce:]
DIGital
:INPut
:DATA? Reads the state of the digital control port.
:OUTPut
:DATA < value > Sets the state of the digital control port.
:PIN<1-7>
:FUNCtion < function > Sets pin function. DIO|DINPut|FAULt|INHibit|ONCouple|OFFCouple |TOUTput|TINPut
:POLarity POSitive|NEGative Sets the pin polarity.
:TOUTput
:BUS
[:ENABle] 0|OFF|1|ON Enables or disables BUS triggers on digital port pins.
[SOURce:]
1 Quick Reference
28 Keysight N69100 Series Operating and Service Guide