68 Getting Started Guide
Front and Rear Panel Functions
Front Panel Features
RF Transceiver Status Indicator
RF Transceiver A/B Status Indicator Light settings:
1.
The LEDs display meaningful information to you only after you have
launched the test application. At this time the LEDs displayed are the
result of your selection or de-selection of duplex mode of the RF Output
1/2 (A) box on the System tab of the Application.
2.
When RF Duplex mode is de-selected, channel 1 is configured in simplex
mode. (Tx1 connector is used for transmission.) The following LEDs are lit
in this mode:
—
LED - Tx1
—
LED - Rx1
—
LED - Rx2 - This receiver connection is not used by the test
application.
—
LED - Tx2 - This transmitter connection is not used by the test
application in 1x1 antenna configuration.
3.
When RF Duplex mode is selected:
—
In this mode, channel 1 is configured in duplex mode (Tx1Rx1/Rx1
connector is used for transmission). The following LEDs are lit in this
mode:
—
LED - Rx1
—
LED - Tx1Rx1
—
LED - Rx2 - This receiver connection is not used by the test
application.
—
LED - Tx2 - This transmitter connection is not used by the
test application inn 1x1 antenna configuration.
—
Channel 2 cannot be configured in duplex mode from the test
application and, in consequence, is always working in simplex
mode; therefore, channel 2 LEDs will never change once the test
application is running.
4.
As receptions are not configurable (there is only one possible connector
for reception on each channel), all receiver LEDs in both RF Transceivers
are always be On.
