Getting Started Guide 65
Front and Rear Panel Functions
Front Panel Features
Number
Item Name
Description
1
HDMI Output
This is a High Definition Multimedia Interface output. This output transfers
uncompressed video data and compressed or uncompressed audio data to an
external display (for example: projector or other type of video/audio display. It
is a standard HDMI v1.3.
2
Front LAN Connection
This RJ-45 connector provides front-panel access from the UXM Host PC
enabling a maximum Ethernet data rate of 1 Gigabit. This connector is used for
downloading firmware upgrades, new test set applications, saving data to an
external memory drive and other reasons for which you may wish to connect to
a local area network and/or to the internet. See
. The IP address for this input is labeled “Front” and can be viewed by
using the CONFIG button on the E7515A Control Panel; see
.
3
2 - USB Inputs
Universal Serial Bus inputs for peripheral devices (mouse, keyboard, flash
drives). These are USB version 2.0.
4
UXM Power Status Light
a
Displays the power status of the instrument.
The rear-panel switch must be turned On and line power must be connected in
order for this light to illuminate.
5
Power
This is the On/Off button for AC power. Pressing this button when the
instrument is powered off turns it on. Pressing this button briefly will shut down
the UXM and Windows Operating System safely. (Pressing and holding this
button down for more than 5 seconds forces a complete instrument
shut-down, but this is not recommended, as it triggers an uncontrolled
Windows shutdown).
6
Earth Ground
Available for those situations where earth ground is required.
7-10
R ports for Transceiver B
b
(RFM2)
These ports transmit and receive using the Transceiver B
emulator of the UXM.
7
Tx2
This provides the secondary RF output port for Transceiver B
safe input level is 0.5W (+27 dBm), -15 to 0 VDC.
8
TxRx2/Rx2
This secondary Transceiver B
port acts in duplex mode, when it transmits and
receives RF signals or in simplex mode when it only receives RF input. The
maximum safe input level is 1W (+30 dBm), ±10 VDC.
9
TxRx1/Rx1
This primary Transceiver B
port acts in duplex mode, when it transmits and
receives RF signals or in simplex mode when it only receives RF input. The
maximum safe input level is 1W (+30 dBm). The Absolute Maximum Power is
2W (+33dBm), 0V DC input voltage.
10
Tx1
This provides the primary RF output port for Transceiver B
. The maximum safe
input level is 0.5W (+27 dBm). The Absolute Maximum Power is 1 W (+30dBm),
0V DC input voltage.
