Installation
25 / 61
2019/11
010-917_SON_EN
3.3.1.3 Initialising the control unit
Dry running of the pump(s) must be avoided at all costs. Do not press the
Start / Stop
key!
• Switch the power supply on and move the main switch to the ON position, the menu “3.8.1”, page 48
appears on the display.
If the display does not offer menu 3.8.1 (initialisation), the control unit has already been initialised. In this case,
the parameters set (in accordance with the list below) must be checked via the operating menu (for operation
of the control unit and the operating menu page 47).
During initialisation, the following input is expected:
– Language
– Date / Time
– Nominal size
– Number and power of the pumps
Language
• Press OK.
• Use the cursor keys to select the language and apply by pressing OK, the menu
Date/Time
appears.
Date / Time
•
Set the respective flashing figure in date and time and apply by pressing OK. Following the last entry, the
menu
Nominal size
appears. The date for emptying also appears and is automatically saved (to change see
„6.1 System type D“, menu 2).
Nominal size
•
Select the nominal size in accordance with the type plate specifications and apply by pressing OK, the menu
Number of pumps
appears.
Number of pumps
•
Select the number of pumps / capacity (see pump type plate(s)) and confirm by pressing OK, initialisation is
completed and the menu
System info
with the settings just made appears.
• There is only one pump installed with nominal sizes 2, 4, 7, 10 and 15.
• There are two pumps installed with nominal sizes 20, 25 and 30.
