KEPCO BOP 5-20DL, Operator'S Manual

Page: 30 / 70

2-6
BOP 5-20DL 081915
2.6 INSTALLATION OF FULL-RACK BOP MODELS
NOTE: For all installations into confined spaces, care must be taken that the temperature
immediately surrounding the unit does not exceed the maximum specified ambient
temperature (55° C).
Refer to the Mechanical Outline Drawing, Figure 1-5 for Full Rack models. Full-rack BOP mod-
els are delivered with the Fixed Angle Brackets and the Chassis Side Support Bars installed.
For bench operation, both of these components may be removed. The full-rack BOP unit may
be installed into standard (19-inch) equipment racks, or onto any other flat surface after remov-
ing the four (4) bottom aluminum feet. If chassis slides are not used, the BOP may be installed
onto any flat surface by means of the provided plastic mounting inserts on the bottom of the
BOP chassis.
NOTE: If slide installation (as described below) is not desired, other means of supporting the
unit in the rear must be provided (additional rear brackets or a solid platform, for exam-
ple) since the front angle brackets alone are not sufficient to support the full weight of
the unit.
2.6.1 SLIDE INSTALLATION.
The Chassis Slide Support Bars of the BOP are pre-drilled to accept Jonathan Series 110 QD
slides. The slides listed in Table 2-3 can be accommodated.
To install the slides, refer to Figure 2-4 and proceed as follows:
1. Remove screws “A” through “E” from left and right chassis slide support bars. (Do not dis-
card).
2. Determine the required hole-pattern for the selected slide model from Table 2-3.
3. Drill the “E” hole into both left and right chassis sections of slide if required.
4. Mount the chassis section of the slide to the left and right side of the BOP as shown in Fig-
ure 2-4. Use the same 10-32 x 1/2” mounting screws removed in step 1.
TABLE 2-3. CHASSIS SLIDE MOUNTING HOLES
MODEL
MOUNTING HOLES USED
A B C D E
110 QD-20-2 X X O X DR
110 QD-22-2 X O X O X
110 QD-24-2 X O X O DR
KEY: X = Hole Used
O = Hole Not Used
DR = Hole must be drilled into chassis part of slide,
each side, 0.199 in. dia., 16-1/4 in. from “A” hole.