11
Note type;
Divide ratio;
CPQN
Crotchets 24
1
Crotchet
triplets
16
Quavers
12
2
Quaver
triplets
8
3
Semiquavers
6
4
Semiquaver triplets
4
6
Demisemiquavers
3
8
Demisemiquaver
triplets
2
12
SYNC CLOCK Polarity: +ve/-ve clock pulse
(default: +ve)
- sets the type of clock pulse sent from the clock pulse output.
Most synths, sequencers & drum machines require this to be set to +ve, but there may be a few that
require it to be set to Inverted (including the KORG MONOPOLY)
SYNC MIDI CLOCK Continue is ignored/= start
(default: ignored)
- If set to ‘ignored’, MIDI continue messages are ignored unless immediately preceded by a ‘song
position pointer’ zero message – in which case they are automatically treated as a ‘start’. If set to
Continue=start, MIDI continue messages are always treated as if they were MIDI ‘start’ messages.
PROBLEMS YOU MAY ENCOUNTER WHEN USING MIDI CLOCK
When using the MIDI clock in conjunction with the Pro-2000 mkII please note the following. The Kenton
add-on cannot sync the arpeggio if it is not actually receiving the MIDI clock. This is not as silly as it
sounds, there are a few points to watch for:-
Some MIDI mergers & patch bays actually remove MIDI clock information from the MIDI data stream
or you may have to enable it for the port you are using.
Users of CUBASE note that the default for MIDI clock is for it NOT to be sent, you will have to go into
MIDI Synchronization page and select MIDI Clock to transmit.
Users of UNITOR/EXPORT on an Atari note that the MIDI clock will only come out of port A, (that is the
Atari's own MIDI port), unless you can re-assign it.
SYSTEM SETTINGS
SYSEX DEVICE NUMBER
(1 to 16, default: 1)
- sets a device number for the unit in case you have more than one pro-2000 and want to control
each independantly
POLY CHAN ACTIVE
(None, A+B, +Aux12,+Aux34,+Aux56, default: None)
- This setting lets you decide which synth channels are assigned for use in poly mode.
Options are:
None - All Mono (default)
A+B only (2 voice)
A+B+Aux12 (3 voice)
A+B+Aux12+34 (4 voice)
A+B+Aux12+34+56 (5 voice)
Polyphonic mode is active when this parameter is set to anything other than "None - All Mono"
If you are using more than just channels A+B, then the Aux outputs must be used in pairs:
Aux 1 with Aux 2, Aux 3 with Aux 4, Aux 5 with Aux 6. Auxes not being polyphonically
controlled will continue to be independent. Remember to set the Auxes to CVs or Gates.
