18
Pro-2000 mkII KADI/Wasp Connector; (Pro-2000 mkII end of cable)
15 way high density D plug (viewed from terminals).
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Wasp wiring;
1
Kybd Data (least significant bit) (0) 5
Kybd Data (Next significant bit) (4)
2
Kybd Data (Next significant bit) (1) 6 Kybd Data (Most significant bit) (5)
3
Kybd Data (Next significant bit) (2) 7
NC
(No Connection)
4
Kybd Data (Next significant bit) (3) 8
Note-On Trigger
screen all remaining wires, (insulate screen).
Pro-2000 mkII DIN sync port connections:
5 pin 180 degree DIN connector
Pin 1 - Stop = 0 volts Start = +5 volts (or continue if selected)
Pin 3 - 5 volt pulses; 24 clocks (pulses) per quarter note, the same as MIDI
Pin 2 - Ground (zero volts)
Pins 4 & 5 are not used.
CONNECTING YOUR MODIFIED TB303 (5 SOCKET RETRO)
TO THE Pro-2000 mkII
Pro-2000 mkII
to
TB303
CV CHANNEL A
>
CV IN
GATE CHANNEL A
>
GATE IN
AUX1
>
FILTER
AUX2
>
SLIDE
AUX3
>
ACCENT
Set the AUX sources to which ever MIDI controller you wish to control the Filter, Accent or Slide, and
link them all to CV channel A (or which ever you are using).
Using Slide;
The AUX2 controller range should be set to 0 minimum, and 50 maximum. Reset value should be 0. To
turn the SLIDE on/off, the MIDI controller must be set to 65 for on, and 0 for off. When the slide is on, all
following notes will glide into each other. It is best to play legato style for good results.
Using Accent;
The AUX3 controller range should be set to 0 minimum, and 50 maximum. Reset value should be 0. To
turn the ACCENT on/off, the MIDI controller must be set to 65 for on, and 0 for off.
