![background image](http://html2.mh-extra.com/html/keithley/sourcemeter-2601/sourcemeter-2601_reference-manual_4018913040.webp)
1-16
Return to
2600S-901-01 Rev. C / January 2008
Section 1: Getting Started
Series 2600 System SourceMeter® Instruments Reference Manual
•
ENABLE
• DISABLE
Via remote, use the
beeper.enable
command to control the beeper. For
example, the following enables the beeper:
beeper.enable = 1
Display modes
Use the
DISPLAY
key to cycle through the various display modes shown in
(Models 2602, 2612, and 2636 only) Press
the Display
key more than once to cycle through the
dual channel and single channel display modes. This applies to CHANNEL A (SMU A) and
CHANNEL B (SMU B).
The Models 2601, 2611, and 2635 are a single channel (SMU A). The User State display
messages are defined with specific display commands (refer to
for more information on
display messaging).
Figure 1-4
Display modes
User State
. V . V
SrcA:+000.000mV SrcB:+000.000mV
. V
SrcA:+000.000mV LimA:100.000mA
. V
SrcB:+000.000mV LimB:100.000mA
Press
DISPLAY
key
Press
DISPLAY
key
Press
DISPLAY
key
Press
DISPLAY
key
Source-Measure display for SMU A and SMU B:
Top line displays the measure function (V, A,
W
or W).
Bottom line displays the source function (V or A)
and level.
Source-Measure and Compliance Limit display for SMU A:
Top line displays the measure function (V, A,
W
or W)
Bottom line displays the source function (V or A) and level,
and the compliance limit (A or V).
Source-Measure and Compliance Limit display for SMU B:
Top line displays the measure function (V, A,
W
or W)
Bottom line displays the source function (V or A) and level,
and the compliance limit (A or V).
Display for user-defined messages and prompts.
Indicates that a measured reading has not been
triggered.